Rain and Storm
Water Pumping Stations

IMPORTANT NOTES: 

• An inlet has not been pre-drilled on the chamber, this allows the inlet to be positioned and cut on site by the customer to ensure perfect alignment for your project. This Unit is supplied with a 110mm inlet seal
• It is important to allow a minimum distance of 450mm between the position of the inlet pipe and the base of the chamber to allow for the pump to operate correctly and without problems.
• Our pumping stations require a single phase 240V electric supply per pump, unless stated otherwise by Pump Stations Direct or a different pump is requested by you over the phone. Due to risks of water and electricity, a qualified electrician is required to safely wire the pump to the mains.
• The cost of delivery* is included with this product, however the offloading is the responsibiliy of the customer.
• The customer must inform us of any poterntial obstacles the courier may face for example; low bridges, narrow roads and sharp narrow corners. If the courier cannot deliver your order due these reasons and we wasn’t aware of them, a re delivery fee of £50 will be charged.